Kussmaul Pump Plus 2000
The Pump Plus 2000 is a small air compressor and a completely automatic, dual independent output, battery charger. The compressor is a standard Auto Pump. The automatic charger maintains 2 sets of batteries under independent control with a maximum output current of 15 amps. The 3 amp Battery Saver powers accessories and removes their load from the battery whenever A.C. power is applied to the charger.
The Pump Plus 2000 charger independently senses the two sets of batteries in the vehicle and recharges each one exactly as much as required. When the batteries are fully charged, all charging stops. The state of charge of the two sets of batteries is indicated on a remotely located bar graph display whenever power is applied to the vehicle. The Battery Saver contained in the Pump Plus 2000 charger is a 3 Amp power supply with a relay to remove the accessory loads from the battery and connect them to the power supply when the charger is energized with A.C. power. This permits the charger to recharge the batteries without supplying the accessory load.
A Selector Switch is provided on the charger to operate the compressor either as a D.C. compressor or as an A.C. compressor. In either switch position the compressor operates from the vehicle's battery. When "D.C." is selected, the compressor operates whenever the pressure switch senses low system pressure. This is useful when parking the vehicle away from the 120 volt input power. For those operators who wish to limit compressor operation to the times when the shoreline is connected to the vehicle, the Selector Switch should be placed in the "A.C." position. This will operate the compressor when the A.C. power is available, but shuts off the compressor when the shoreline is removed. In either switch position the compressor is operated by the vehicle's battery.
Pump Plus 2000, model #091-9-2000
-
Input: 120 volts, 50/60 Hz., 3.5 amps
-
Output: Two independent outputs, 12 VDC, @ 15 amps. max
-
Voltage Sense: remote, electronic, no sense wires required
-
Battery Saver: Output Voltage 12 VDC Output Current 3 amps
-
Indicators: Power - indicates input power applied
-
Battery Saver Overload Indicator: Indicates Battery Saver load exceeds 3 amperes.
-
Charger Output Indicator: Remotely located bar graph display, indicates state of charge and condition of battery.
-
Warranty: 3 Years
Auto Pump, Model #091-9:
-
Input: 12 volt DC @ 12 amps
-
Output: .30 SCFM @ 80 PSI, .35 SCFM @ 60 PSI
-
Motor Type: Permanent Magnet, .10 H.P.
-
Warrenty: 1 Year
Categories
